Then draw a line from the end of Task A to the end of Task B. To create a Finish to Finish type of predecessor between two tasks, simply hover over Task A until you see two circles appear on each end. Then draw a line from the start of Task A to the start of Task B. To create a Start to Start type of predecessor between two tasks, simply hover over Task A until you see two circles appear on each end. Then draw a line from the end of Task A to the start of Task B. To create a Finish to Start type of predecessor between two tasks, simply hover over Task A until you see two circles appear on each end. You can define predecessor relationships by drawing a line between Project Tasks to connect them. Populating the Predecessor Information for Tasks on the Gantt Chart.Drawing a line between Project Tasks, OR.The image below shows an example of a Start-to-Finish type of predecessor.ĭefining predecessor relationships between Project Tasks in the Gantt Chart is done by either: The image below shows an example of a Start-to-Finish type of predecessor. When a Start-to-Finish predecessor is used to connect two tasks, this means that Task A cannot finish until Task B starts. Start-to-Finish relationships are the least commonly used in project planning. The image below shows an example of a Finish-to-Finish type of predecessor. When a Finish-to-Finish predecessor is used to connect two tasks, this means that both tasks finish at the same time. However, these tasks can begin at different points in time. The image below shows an example of a Start-to-Start type of predecessor. When a Start-to-Start predecessor is used to connect two tasks, this means that both tasks start at the same time. However, these tasks can finish at different points in time. The image below shows an example of a Finish-to-Start type of predecessor. When a Finish-to-Start predecessor is used to connect two tasks, this means that Task B cannot start before Task A is finished. Inspire Planner supports the four (4) common types of dependencies:įinish-to-Start predecessors are the most commonly used type of dependency. Defining Predecessors within the Gantt ChartĪs you create Project Tasks and specify their Duration, Start and Finish Dates, Inspire Planner automatically plots them in the Gantt Chart.Įxample of Gantt Chart with Predecessor Connections between Project Tasks.By manually entering a value in the Predecessor Field.Populating the Predecessor Column (see article on Creating Dependencies with Predecessors).Predecessor relationships can be created either by: Predecessors specify the relationships between project tasks and indicate when a task should begin or end in relation to other tasks.
0 Comments
Leave a Reply. |